Most embedded Linux /
BSD systems such as routers, servers and nas devices comes with console
interface (serial port with RS-232). BIOS can use this, and after boot BIOS
screen I/O is redirected so that you can use the device. RS-232 is also used
for communicating to headless server, where no monitor or keyboard is
installed, during boot when operating system is not running yet and therefore
no network connection is possible. You need to use a serial cable between your
computer and embedded system or server. In this post I will cover five common
utilities used for serial communication under Linux / Unix / *BSD and Mac OS X.
Find
out information about your serial ports
Type the following dmesg command:
$ dmesg | egrep --color 'serial|ttyS'
Sample outputs:
[ 1.245258] serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
[ 1.265727] serial8250: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
[ 1.286713] 00:07: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
[ 1.307321] 00:08: ttyS1 at I/O 0x2f8 (irq = 3) is a 16550A
You can use setserial
command which is designed to set
and/or report the configuration information associated with a serial port:
$ setserial -g /dev/ttyS[0123]
Sample outputs:
/dev/ttyS0, UART: 16550A, Port: 0x03f8, IRQ: 4
/dev/ttyS1, UART: 16550A, Port: 0x02f8, IRQ: 3
/dev/ttyS2, UART: unknown, Port: 0x03e8, IRQ: 4
/dev/ttyS3, UART: unknown, Port: 0x02e8, IRQ: 3
#1
cu command
The
cu command is used to call up another system and act as a dial in terminal. cu
command is installed on many Unix like systems including OpenBSD/AIX/Solaris
and so on. You can use it as follows:
cu -l /dev/device -s baud-rate-speed
In this example, I'm
using /dev/ttyS0 with 19200 baud-rate:
cu -l /dev/ttyS0 -s 19200
Sample outputs:
To exit enter tilde dot (~.).
#2
screen command
Use the screen command as follows:
$ screen /dev/device baud-rate $ screen /dev/ttyS0 19200 $ screen /dev/ttySUSB0 19200,cs8
Sample outputs:
#3 minicom command
minicom command is a communication program which
somewhat resembles the shareware program TELIX from old good MS-DOS days. Type
minicom to connect:
$ minicom
Sample outputs:
#4 putty command
PuTTY is a
free and open source gui X based terminal emulator client for the SSH, Telnet,
rlogin, and raw TCP computing protocols and as a serial console client. It
works under Linux, Unix, Mac OS X, MS-Windows and few other operating systems.
You can use the apt-get or yum command to install putty:
$ sudo apt-get install putty
$ yum install putty
#5
tip command
The tip command is used as a serial terminal.
tip command can be found under AIX/HP-UX/Solairs/*BSD/Linux operating systems.
The syntax is:
tip -19200 device
tip -19200 s0
tip -19200 ttys0
0 comments:
Post a Comment